Ps-engineering PMA8000BT User Manual download pdf (Page 14)

Page 14 202-890-0702 PMA8000BT Pilot Guide Rev. 4

Recorder Playback

The internal recorder is always storing

the audio from the radio selected for

transmit. To play back the last incom-

ing audio, hold the RCV (top) button on

the radio selected to transmit for one

second, and release. The playback will

start. Playback stops if the radio be-

comes active, but the new incoming

message will not be recorded. When the

radio stops, press play and you will be in the same message you had

playing.

To hear an earlier message, hold the COM RCV button until playback

stops again, and then press again to begin playing the next earlier

message. Repeat until you hear the message you wanted. Incoming

new messages will stop playback, and you can then restart.

A remote playback switch may also be installed.

Note: when you switch from one transmitter to another, the recordings

are lost.

Blinking indicators

This chart shows you what the blinking LEDs mean.

COM 1 or COM 2 XMT Every 1 second Pilot or copilot is transmitting

COM or COM 2 RCV Every 3 seconds Monitor mode activated

ICS mode Every 3 seconds Pilot has music in ISO

Mute and SPR buttons Every 1 second PA Mode active

What is blinking? How often What it means

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Ps-engineering PMA8000BT User Manual Page 14