Ps-engineering PMA7000CAP Installation Manual User Manual download pdf (Page 8)

PS Engineering

PMA7000M-S Series Audio Selector Panel and Intercom System

Civil Air Patrol Version Installation and Operator’s Manual

200-072-0004 Page 2-1 Rev. 4, Sept. 2000

Section II - Installation

2.1 GENERAL INFORMATION

2.1.1 SCOPE

This section provides detailed installation and interconnect instructions for the PS Engineering

PMA7000M-Series Audio Selector Panel/Intercom System with internal Marker Beacon.

Please read this manual carefully before beginning any installation to prevent damage and post-

installation problems. Installation of this equipment requires special tools and knowledge.

NOTE: An appropriately rated Certified Aircraft Repair Station must install this equipment in

accordance with applicable regulations. PS Engineering, Incorporated warranty is not valid

unless the equipment installation is supervised by an authorized PS Engineering, Incorporated

dealer. Failure to follow any of the installation instructions or installation by a non-certified

individual or agency will void the warranty, and may result in an unairworthy installation.

2.2 Unpacking and Preliminary Inspection

Use care when unpacking the equipment. Inspect the units and parts supplied for visible signs of

shipping damage. Examine the unit for loose or broken buttons, bent knobs, etc. Verify the

correct quantity of components supplied with the list in Section 1.6. If any claim is to be made,

save the shipping material and contact the freight carrier. Do NOT return units damaged in

shipping to PS Engineering. If the unit or accessories shows any sign of external shipping

damage, contact PS Engineering to arrange for a replacement. Under no circumstances attempt

to install a damaged unit in an aircraft. Equipment returned to PS Engineering for any other

reason should be shipped in the original PS Engineering packaging, or other UPS approved

packaging.

2.3 Equipment Installation Procedures

2.3.1 Cooling Requirements

Forced air cooling of the PMA7000M-S is not required. However the unit should be kept

away from heat producing sources (i.e. defrost or heater ducts, dropping resistors, heat

producing avionics) without adequate cooling air provided.

2.3.2 Mounting Requirements

The PMA7000M-S must be rigidly mounted to the instrument panel of the aircraft structure and

within view and reach of the pilot position(s). Installation must comply with FAA Advisory

Circular AC 43.13-2A. The unit may be mounted in any area where adequate clearance for the

unit and associated wiring bundle exist.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 33 34

No comments

Ps-engineering PMA7000CAP Installation Manual User Manual Page 8