Ps-engineering PDA360EX Installation Manual User Manual download pdf (Page 24)

PS Engineering Inc. ®

PAR100EX Audio Selector Panel and Intercom System

Installation and Operator’s Manual

200-760-0000 Page 2-17 Rev. 12, Jan. 2014

Beware of fabric surfaces with silver dope finishes. The silver dope is a conductive surface, and will

screen antennas which are mounted internally. Refer to the Microair Avionics website

www.microair.com.au for more detail on antennas suitable for non-metal skin aircraft.

2.13.3 Antenna Location

For best results while in Split Mode, we recommend that the one VHF communications antenna is located

on top of the aircraft while the other communications antenna is installed on the bottom. Any antenna

relocation must be accomplished in accordance with AC 43.13-2B, aircraft manufacturers’ recommenda-

tions, and other FAA-approved technical data.

WARNING

It is probable that radio interference will occur in the split mode when the frequencies of the two air-

craft radios are adjacent, and/or the antennas are physically close together. PS Engineering makes

no expressed or implied warranties regarding the suitability of the PAR100EX in Split Mode.

2.14 M760REM Adjustments

The microphone gain and sidetone are adjustable via the trim pot(s) which can be accessed

via the small hole(s) in the side of the chassis.

Figure 2-8 Radio Adjustment Locations

Figure 2-9 Sidetone adjustment range

The radio receive audio level is adjusted at the rear of the case.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 40 41

No comments

Ps-engineering PDA360EX Installation Manual User Manual Page 24